Kenwood NEXEDGE NX-200 Function Reference page 250

9 NXDN TRUNKING SYSTEM
9.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Message Trunked (Enhanced))
2
Receive from the system a message for traffic channel assignment.
The Call In Progress Tone sounds from the transceiver, the ID for
the receiving transceiver appears on the main display, and the
transceiver becomes enabled for the transmission by means of
an Individual Call.
Receiving a message for traffic channel assignment while the
PTT switch is being pressed and held starts transmission by an
Individual Call. If PTT Proceed Tone is configured to be enabled,
a PTT Proceed Tone sounds from the transceiver at this time.
3
Press the PTT switch.
The Individual Call is initiated.
Even after the PTT switch is released to end the transmission, the
link between the transceiver and the traffic channel is maintained.
4
Press the Side 1 key (Portable), the
The Individual Call ends. A Disconnect Indication Tone sounds
from the transceiver, the link to the traffic channel is terminated,
and the transceiver display reverts to the GID display.
Note
• The DTMF code can be sent during the call by pressing one of the [0] key to [9] key, the [*] key or the [#] key while pressing and
holding the PTT switch.
• If the Call Request Tone is enabled, a Call Request Tone sounds from the transceiver when a call requesting an Individual Call
(Message Trunked (Enhanced)) is initiated. Also, if the Call Processing Tone is enabled, a Call Processing Tone sounds from the
transceiver until the transceiver receives from the system a message for traffic channel assignment after the call requesting an
Individual Call (Message Trunked (Enhanced)) is initiated. (Refer to
Initiated (Call Request Tone)/ Notifying the User with a Tone That a Call Request Is in Progress (Call Processing Tone) on page
• If PTT Proceed Tone is enabled, a Proceed Tone sounds from the transceiver when the transceiver becomes ready for
communications after the PTT switch is pressed. (Refer to
Tone) on page 92.)
• For Mobile, if the Mic On-hook Disconnect is enabled, an Individual Call terminates by placing the microphone in the on-hook state.
• A transceiver cancels a call if the transceiver receives a message from the system to notify that no response has been received by the
system from the transceiver. In this case, "<<NO REPLY>>" appears on the main display for 1 sec.
• For details on the information displayed on the main display during transmission, refer to
FUNC (K)/Ver 4.00
Triangle key (Mobile), or the
Notifying the User with a Tone That a Call Request Has Been
Using Sound to Notify the Timing to Start Communications (PTT Proceed
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
[#] key.
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
 Display during transmission on page
CONTENTS INDEX
212.)
207.
216