Kenwood NEXEDGE NX-200 Function Reference page 408

14 DTMF
14.4 Functions Related to DTMF Code Encoding
Note
If the first digit of the DTMF code is the * tone or # tone, the transceiver compares the extension time to send the first digit configured
for the First Digit Time with the * and # Digit Time and uses the longer extension time to send the first digit.
Configuration using KPG-111D/ DN
Configuring the * and # Digit Time (
DTMF Hold Time
DTMF Hold Time is the amount of time from when the keypad is disabled until the transceiver restores the receive mode
while sending the DTMF code using Keypad Auto PTT or Manual Dialing.
The DTMF signal received until its transmission is interrupted may be treated as one string of code depending on the
devices on the receiving side. Therefore, the transceiver holds the transmission not to interrupt the digit sequence when
sending a continuous DTMF signal.
Configuration using KPG-111D/ DN
Configuring the DTMF Hold Time (
D Code Assignment
D Code Assignment can be used to configure whether the D Code is used for the D tone of DTMF or a dialing pause
(unmodulated transmission).
Configuration using KPG-111D/ DN
Configuring the D Code Assignment (
Emitting the DTMF Code Tone (Sidetone)
Sidetone is the function to emit the tone of the DTMF code from the speaker while the transceiver transmits the DTMF
code.
Note
• If "Silent" is configured for the Emergency Mode Type, the transceiver does not emit the DTMF Sidetone in Emergency Mode. (Refer to
Emergency Mode Type on page
• If the transceiver sends the DTMF code while PTT Proceed Tone is enabled, the transceiver does not emit the Proceed Tone. (Refer to
Using Sound to Notify the Timing to Start Communications (PTT Proceed Tone) on page
Configuration using KPG-111D/ DN
Configuring the DTMF Sidetone to be enabled or disabled (
FUNC (K)/Ver 4.00
FPRG 8.14.1 Encode Tab)
See
See FPRG 8.14.1 Encode Tab)
See FPRG 8.14.1 Encode Tab)
401.)
92.)
See FPRG 8.14.1 Encode Tab)
CONTENTS INDEX 374