Sending Gps Data Together With Status Call; Gps Functions - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync
12.9 Sending GPS Data
Sending GPS Data Together With Status Call (GPS Combination)
The transceiver can send GPS data by adding the GPS data to a Status Message using FleetSync.
To use this function, Status for GPS Combination must be enabled by using KPG-111D/ DN. The range of status numbers
to which GPS data can be added can be configured.
Status + GPS
Configuration using KPG-111D/ DN
• Configuring the GPS Combination (Status) (
• Configuring the GPS Report Status Number Block (
Sending GPS Data Together With Emergency Call (GPS Combination)
The transceiver can send GPS data by adding the GPS data to the Emergency ID (FleetSync).
To use this function, Emergency for GPS Combination must be enabled by using KPG-111D/ DN.
Note
GPS data will not be added to the Emergency ID (DTMF) and Emergency ID (ANI Board).
Configuration using KPG-111D/ DN
Configuring the GPS Combination (Emergency) (

GPS Functions

The following functions are relevant to GPS data transmission.
• Number of Times
• GPS Report Interval Time
• GPS Time Mark
• GPS Message Type
• GPS Report on Data Zone-CH/GID
• GPS Data Storage
• GPS Report CH/GID
• GPS Report Back to Requested ID
• GPS ACK Request
Refer to 15.1 GPS Functions on page 384
FUNC (K)/Ver 4.00
Figure 12-9 Timing to Send GPS Combination (Status)
See
Emergency + GPS ID
Figure 12-10 Timing to Send Combination (Emergency)
See
for details of each function.
St
GPS
FPRG 8.16.8 GPS Tab)
See FPRG 8.16.8 GPS Tab)
ID
GPS GPS
FPRG 8.16.8 GPS Tab)
Transmit
Receive
Transmit
Receive
CONTENTS INDEX 347