Sending And Receiving A Status Message (Status Call); Sending A Status Message - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync

12.6 Sending and Receiving a Status Message (Status Call)

12.6 Sending and Receiving a Status Message (Status Call)
Status Message is a simplified messaging system that allows a user to send or receive a status message (Statuses 10 to
99) by selecting numbers. With this function enabled, the dispatcher, etc. can send a message to the transceiver.
The following methods are available to send a Status Message.
Item
The transceiver enters Status Mode by a user pressing a PF key or a key on the keypad, and then the
Status Mode
transceiver will send a Status Message. (Refer to
Pressing one of the Call 1 to Call 6 keys causes the transceiver to send the preconfigured Status Message.
Call 1 to Call 6 can be assigned to the PF keys using KPG-111D/ DN and the Status Message corresponding to
Call key
each key can be selected from the Status List in FleetSync.
In this case, the receiving party is fixed to the target party.
The transceiver sends the Status Message configured using KPG-111D/ DN when the transceiver is turned ON
Turning the
or OFF. (Refer to
transceiver ON/ OFF
In this case, the receiving party is fixed to the target party.
The transceiver will send a Status Message when the transceiver receives a PC command from the
PC Command
communication port.
Note
For NX-200S/ NX-300S, the transceiver cannot send a Status Message by using Status Mode.
Configuration using KPG-111D/ DN
• Assigning functions to the PF keys on the transceiver (
• Configuring the Status Message corresponding to the Call 1 to Call 6 keys (

Sending a Status Message

This section describes how to send a Status Message in Status Mode.
The transceiver enters Status Mode with one of the following operations, and then the transceiver will send a Status
Message.
 Status (FleetSync/NXDN) or Selcall + Status (FleetSync) key
Pressing the Status (FleetSync/NXDN) key places the transceiver in Status Mode. In this case, a Status Message is
addressed to a Target Fleet/ ID.
Pressing the Selcall + Status (FleetSync) key causes the transceiver to enter Selcall Mode. The transceiver enters
Status Mode by a user pressing the Menu ([
Initiating a Selective Call on page
 Menu key
The transceiver enters Status Mode when "Status (FleetSync/NXDN)" is selected to after entering Menu Mode by
pressing the Menu key. In this case, a Status Message is addressed to a Target Fleet/ ID.
The transceiver enters Selcall Mode when "Selcall + Status (FleetSync)" is selected after a user presses the Menu key
to enter Menu Mode. The transceiver enters Status Mode by a user pressing the Menu ([
the target transceiver's Selcall ID. (Refer to
Refer to 3.4 Using Menu Mode on page 23
FUNC (K)/Ver 4.00
Table 12-11 Sending Status Messages
Power-on Status Message on page
See
]) or [*] key after selecting the target transceiver's Selcall ID. (Refer to
309.)
Initiating a Selective Call on page
for operations in Menu Mode.
Description
Sending a Status Message on page
333, Power-off Status Message on page
FPRG 8.12 Key Assignment Window)
See FPRG 8.12.6 Call Tab)
309.)
CONTENTS
323.)
333.)
]) or [*] key after selecting
INDEX 323