Kenwood NEXEDGE NX-200 Function Reference page 236

9 NXDN TRUNKING SYSTEM
9.3 Registration in an NXDN Trunking System
• If the transceiver information registered in the system is already cleared when the transceiver initiates a Group
Call, the transceiver begins Group-registration and then the transceiver will terminate the Group Call upon receipt
of a response message from the system indicating non-registration of the group in the system.
Note
• The transceiver may not be able to receive a Group Call using the Group ID without group registration in the system. This depends on
the system configuration.
• If receiving a Group ID differing from the Group ID for the group registered in the system, the transceiver will not begin Group-
registration at the time of receiving the call.
• If a Group ID is added to the transceiver by receiving a request for changing the remote group, the transceiver will begin Group-
registration 2 sec after changing to add the Group ID. If the transceiver restores to the previous GID upon receipt of a message
requesting to reset the change of the remote group, the transceiver will begin Group-registration 2 sec after changing to that Group ID
of the GID. (Refer to 9.17 Adding a Group ID by Remote Control (Remote Group Add) on page
• For NX-200S/ NX-300S, the status of the transceiver can be confirmed by a tone sounded from the transceiver.
Configuration using KPG-111D/ DN
• Configuring the Group-registration Invalid Indicator (
• Configuring the Group-registration Invalid Tone (
Clearing the Registration Information from a System (Registration Clear)
The transceiver can clear from the system the information about the transceiver location registration.
Conditions for the Transceiver to Clear the Transceiver Location Registration Information
from the System
The transceiver clears from the system the information about the transceiver location registration under the following
conditions.
• If the transceiver is turned OFF
The transceiver will be turned OFF after clearing from the system the information about the location registration. If
Power-off Status Message is configured, the transceiver will clear from the system the information about location
registration after sending the Power-off Status Message.
In Portable, if the transceiver is turned OFF by a user removing the battery pack, the transceiver will not clear
from the system the information about the location registration.
• If the zone is changed to a zone in other than an NXDN Trunking System
The transceiver will migrate to the changed zone after clearing from the system the information about location
registration.
Transceiver's Behavior if Clearing the Information about Location Registration from the
System
If the transceiver receives from the system a response message (indicating permission, rejection or failure), the
transceiver does not receive any response from the system, or the timer for random access expires, the transceiver will
refresh the information about the site from where the information of the location registration has cleared.
FUNC (K)/Ver 4.00
FPRG 8.25.8 Group-registration Invalid Indicator)
See
FPRG 8.25.9 Group-registration Invalid Tone)
See
240.)
CONTENTS INDEX 202