Kenwood NEXEDGE NX-200 Function Reference page 205

8 NXDN CONVENTIONAL SYSTEM
8.12 Using DTMF to Initiate a Selective Call/ 8.13 Communicating using a CW Message
Long Message on Data Zone-CH/GID
Long Message on Data Zone-CH/GID is the function that allows the transceiver to automatically change the channel to the
Data Zone-channel or GID to send a Long Message in an NXDN Conventional system.
The channel in an NXDN Conventional system is automatically changed to the channel configured for a Data Zone-CH/
GID (NXDN) to send the Long Message. The transceiver restores the last Zone-channel or GID when the transmission
ends. Long Message on Data Zone-CH/GID allows the transceiver to send data on a specific dedicated channel.
Note
This function can be only used in an NXDN Conventional system.
Configuration using KPG-111D/ DN
• Configuring the Long Message on Data Zone-CH/GID to be enabled or disabled (
Tab)
• Configuring the Data Zone-CH/GID (NXDN) (
8.12 Using DTMF to Initiate a Selective Call
DTMF Encode and the related functions can be used in an NXDN Conventional system. However, the PTT ID function is
unavailable.
Also, to decode a DTMF code in an NXDN Conventional system, "DTMF" needs to be configured as the Optional Signaling
to be used on the channel. (Refer to
Refer to 14 DTMF on page 359
8.13 Communicating using a CW Message
Continuous Wave (CW) is a radio emission type that is used to send and receive Morse code messages over the air.
CW Message is used to send Morse code messages preconfigured in the transceiver by using the PF keys.
Pressing the CW Message key causes the transceiver to send the CW Message.
The transceiver can send a CW Message only on a channel where "Very Narrow" is configured for Channel Spacing in an
NXDN Conventional system. The transceiver will switch to analog modulation mode when the transceiver sends a CW
Message.
A maximum of 32 alphanumeric characters and symbols can be configured and sent.
The CW Message to be sent can be configured using KPG-111D/ DN. The following functions are relevant to sending a
CW Message.
• CW Speed
• CW Modulation Delay Time
• Audio Frequency
• CW Sidetone
Note
CW specifications are compliant with articles in FCC 90.425 Station Identification and International Morse Code.
Configuration using KPG-111D/ DN
• Configuring the CW Message (
• Assigning functions to the PF keys on the transceiver (
FUNC (K)/Ver 4.00
FPRG 8.2.3 Data Zone-CH/GID (NXDN))
See
Using the Optional Signaling (NXDN) on page
for details about DTMF.
FPRG 8.10.4 CW ID Dialog Box)
See
See
119.)
See FPRG 8.12 Key Assignment Window)
CONTENTS
FPRG 8.19.5 Conventional
INDEX 171