14 DTMF
14.1 Method of Sending the DTMF Code
Sending a DTMF Code Selecting from a List (Autodial List)
DTMF code configured for the Autodial List can be selected and sent.
To use this function, Store & Send must be disabled using KPG-111D/ DN.
The transceiver can enter Autodial Mode and the DTMF codes can be selected using one of the following operations:
Autodial key
Pressing the Autodial key causes the transceiver to enter Autodial Mode.
Menu key
Pressing the Menu key places the transceiver in Menu Mode, and then the transceiver enters Autodial Mode by
selecting "Autodial". (Refer to
Keypad entry
If "Autodial" is configured for Keypad Operation, pressing a key(s) on the keypad causes the transceiver to enter
Shortcut Entry Mode for Autodial Mode. (Refer to
Note
This function is unavailable for NX-200S/ NX-300S.
Operating the Transceiver
1
Press the
Autodial
The transceiver enters Autodial Mode and then the Autodial List
Selection display will appear.
The following operations are identical even if the transceiver
enters Autodial Mode by a user pressing the Menu key or with
keypad entry.
2
Press the
Up
or
Down
to select the Autodial List to be sent.
Refer to
Selecting or Clearing Data from a List on page 42
selection methods.
FUNC (K)/Ver 4.00
3.4 Using Menu Mode on page
Keypad Operation on page
key.
key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411), or press the
23.)
21.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
for
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
Mobile
[ ]
or
[ ]
key (Mobile)
Mobile
INDEX
365