Kenwood NEXEDGE NX-200 Function Reference page 255

9 NXDN TRUNKING SYSTEM
9.7 Making a Group Call (Transmission Trunked)
Operating the Transceiver
1
Select the target Group ID by using the
2
Press the PTT switch.
The transceiver starts initiating a call.
Note
• If Call Request Tone is enabled, a Call Request Tone sounds from the transceiver when the PTT switch is pressed to initiate a call
request. Also, if Call Processing Tone is enabled, a Call Processing Tone sounds from the transceiver while the PTT switch is pressed
and held after a call request is initiated by pressing the PTT switch. (Refer to
Been Initiated (Call Request Tone)/ Notifying the User with a Tone That a Call Request Is in Progress (Call Processing Tone) on page
212.)
• If PTT Proceed Tone is enabled, a Proceed Tone sounds from the transceiver when the transceiver becomes ready for
communications after the PTT switch is pressed. (Refer to
Tone) on page 92.)
• The transceiver starts a Group Call only by a user pressing the PTT switch if the transceiver transmits on a channel with "Group Call"
configured for Selcall on PTT. In this case, a Group ID does not need to be selected by using the transceiver.
• For details on the information displayed on the main display during transmission, refer to
Configuration using KPG-111D/ DN
• Assigning functions to the PF keys on the transceiver (
• Configuring the Selcall on PTT (NXDN Trunking System) (
FUNC (K)/Ver 4.00
CH/GID Up or CH/GID Down
Notifying the User with a Tone That a Call Request Has
Using Sound to Notify the Timing to Start Communications (PTT Proceed
See FPRG 8.12 Key Assignment Window)
FPRG 8.9.6 Selcall on PTT)
See
key to initiate a Group Call.
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
 Display during transmission on page
CONTENTS INDEX
207.
221