Kenwood NEXEDGE NX-200 Function Reference page 176

8 NXDN CONVENTIONAL SYSTEM
8.7 Making a Group Call
2
Press the Up or Down
to select a Group ID from the Group ID List.
Refer to Selecting or Clearing Data from a List on page 42
selection methods.
3
Press the PTT switch.
In order to enter a Status Message or Short Message, the Menu
([ ]) or [*] key needs to be pressed. (Only if the transceiver
enters Group Call Mode by a user pressing the Group + Status
(NXDN) or Group + SDM (NXDN) key or selecting Group +
Status (NXDN) or Group + SDM (NXDN) by a user pressing the
Menu key) (Refer to 8.9 Sending and Receiving a Status
Message (Status Call) on page
Note
• If PTT Proceed Tone is enabled, a Proceed Tone sounds from the transceiver when the transceiver becomes ready for
communications after the PTT switch is pressed. (Refer to
Tone) on page 92.)
• The transceiver starts a Group Call only by a user pressing the PTT switch if the transceiver transmits on a channel with "Group Call"
configured for Selcall on PTT. In this case, a Group ID does not need to be selected by using the transceiver.
Configuration using KPG-111D/ DN
• Assigning functions to the PF keys on the transceiver (
• Configuring the Selcall on PTT (NXDN Conventional System) (
Receiving a Group Call
If the received Group ID matches the Group ID configured for the transceiver, the transceiver can receive the Group Call.
Note
To receive a Group Call in an NXDN Conventional system, "NXDN ID" needs to be configured as the Optional Signaling to be used on
the channel. (Refer to Using the Optional Signaling (NXDN) on page
FUNC (K)/Ver 4.00
key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411), or press the
150.)
Using Sound to Notify the Timing to Start Communications (PTT Proceed
for
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
See FPRG 8.12 Key Assignment Window)
See FPRG 8.3.3 Page 1 Tab)
119.)
CONTENTS
[ ] or [ ] key (Mobile)
Mobile
INDEX 142