Kenwood NEXEDGE NX-200 Function Reference page 274

9 NXDN TRUNKING SYSTEM
9.17 Adding a Group ID by Remote Control (Remote Group Add)
9.17 Adding a Group ID by Remote Control (Remote Group Add)
Remote Group Add is the function to make a transceiver receive a message requesting to change the remote group and
add a Group ID by sending the request message for the remote group change from a transceiver connected to a PC.
This function allows the system to establish communications by making target transceivers temporarily participate in a
group or temporarily configuring a new group by gathering mobile stations in different parties.
Note
For NX-200S/ NX-300S, few available PF keys and no LCD display may cause operational confusion. Therefore, we recommend not
changing the Group ID for system operation in NX-200S/ NX-300S.
Sending the Message Requesting to Change the Remote Group or Reset the
Change of the Remote Group
The transceiver connected to a PC sends the message requesting to change the remote group or reset the change of the
remote group.
Operating the Transceiver
 Sending the message requesting to change the remote group
1
Send the command requesting to change the remote group to the transceiver from the PC.
The transceiver sends the message requesting to change the remote group to the specified transceiver using an Individual
Call.
 Sending the message requesting to reset the change of the remote group
1
Send the command requesting to reset the change of the remote group to the transceiver from the PC.
The transceiver sends the message requesting to reset the change of the remote group to the specified transceiver using an
Individual Call.
Note
• To send the message requesting to change the remote group or reset the change of the remote group, "Data" or "Data + GPS Data
Output" must be assigned to the communication port of the transceiver. (Refer to
• The message requesting to change the remote group or reset the change of the remote group can only be sent using an Individual
Call.
Receiving the Message Requesting to Change the Remote Group or Reset the
Change of the Remote Group
The transceiver that receives a message requesting to change the remote group adds the specified Group ID as GID No.
0 to the zone in the NXDN Trunking system where the transceiver received the message. Or, the transceiver that receives
a message requesting to reset the change of the remote group clears the Group ID added as GID No. 0 from the zone in
the NXDN Trunking system where the transceiver received the message.
(Hereinafter, the Group ID that is added using this function is referred to as the Regroup ID.)
FUNC (K)/Ver 4.00
Available Functions for COM Port on page
CONTENTS
524.)
INDEX 240