Kenwood NEXEDGE NX-200 Function Reference page 410

14 DTMF
14.5 Functions Related to DTMF Code Decoding
Transceiver Behavior When Receiving a Selective Call
If the received DTMF code matches the standby DTMF code preconfigured for the transceiver, the transceiver can transmit
the multiplexed Transpond tone, emit an Alert Tone, or blink the LED orange.
Configuration
Transpond The transceiver transmits the multiplexed Transpond Tone.
Alert Tone The configured Alert Tone sounds from the transceiver.
Selective Call Alert
The Transmit LED blinks orange.
LED
Note
• If both Alert Tone and Transpond are enabled, an Alert Tone sounds from the transceiver after the Transpond operation is complete.
• With the Clear To Transpond enabled, if the Transpond operation is suspended since the channel is busy, the Alert Tone operation is
also suspended. (Refer to Clear to Transpond on page
• The matching state of the DTMF codes will be reset in the following conditions. The status of Transpond is reset on the following
conditions while Transpond is suspended. The Transpond will also be suspended if the transmission is disabled by Busy Channel
Lockout.
Transmission
Operation
When the following keys or the Selector is pressed
Pressing a key
*2
Hook When the microphone is in the on-hook state
Expiration of the Auto
When the length of time configured for Auto Reset Timer elapses (Status for DTMF only.)
Reset Timer
Receiving a Code Receiving Code + # code
Transmission is made using the following switch or one of the ports. (This condition is only applicable to
Transpond.)
Transmission
*1
NX-200/ NX-210/ NX-300/ NX-410/ NX-411 only
*2
Mobile only
Configuration using KPG-111D/ DN
• Configuring the Transpond (
• Configuring the Alert Tone (
• Configuring the Selective Call Alert LED to be enabled or disabled (
FUNC (K)/Ver 4.00
Table 14-5 Transpond/ Alert Tone
377.)
Table 14-6 Conditions to Reset the Transpond Function
• Monitor key
• Monitor Momentary key
• Squelch Off key
• Squelch Off Momentary key
• Zone Up key
• Zone Down key
*1
• Zone Up/Down (Selector)
• CH/GID Up key
• CH/GID Down key
• CH/GID Up/Down key (Selector)
• Scan key
• Home CH/GID key
• Direct CH/GID 1 to Direct CH/GID 5 keys
• PTT switch
*2
• External PTT (Voice) port
*2
• External PTT (Data) port
See FPRG 8.14.2 Decode Tab)
FPRG 8.14.2 Decode Tab)
See
Description
Conditions
*1
See FPRG 8.14.2 Decode Tab)
CONTENTS INDEX 376