Kenwood NEXEDGE NX-200 Function Reference page 344

12 FleetSync
12.4 Making a Selective Call
A user can also use a Paging Call to initiate a Selective Call. Paging Call is the function to initiate a call to a target party.
This function can be used to initiate a call without using voice communication.
The transceiver enters Selcall Mode with one of the following options and then will initiate a Selective Call.
 Selcall (FleetSync), Selcall + Status (FleetSync) or Selcall + SDM (FleetSync) key
Pressing the Selcall (FleetSync), Selcall + Status (FleetSync), or Selcall + SDM (FleetSync) keys place the
transceiver in Selcall Mode.
 Menu key
The transceiver enters Selcall Mode by a user selecting "Selcall (FleetSync)", "Selcall + Status (FleetSync)", or "Selcall
+ SDM (FleetSync)" after the transceiver enters Menu Mode by a user pressing the Menu key. (Refer to
Menu Mode on page 23.)
 Keypad entry
If "Selcall (FleetSync)", "Selcall + Status (FleetSync)", or "Selcall + SDM (FleetSync)" is configured for Keypad
Operation, pressing one of the [0] to [9] keys on the transceiver keypad places the transceiver in Selcall Mode. The
transceiver enters Selcall ID Shortcut Entry Mode or goes into the respective state as the first digit of the Selcall ID is
entered. (Refer to Keypad Operation on page
Note
• Auto Reply Message cannot be activated for a transceiver receiving a Paging Call.
• The transceiver can initiate a Supervisor Call and Broadcast Call by selecting a FleetSync ID from the ID List. These calls cannot be
initiated using Manual Dialing.
• For NX-200S/ NX-300S, a Selective Call cannot be initiated by using Selcall Mode. For NX-200S/ NX-300S, a Selective Call can be
initiated only by using PTT ID.
Operating the Transceiver
 Initiating a Selective Call by list selection
1
Press the Selcall (FleetSync),
The transceiver enters Selcall Mode and then the ID List
selection display appears.
The following operations are identical even if the transceiver
enters Selcall Mode by a user pressing the Menu key or with
keypad entry.
FUNC (K)/Ver 4.00
21.)
Selcall + Status (FleetSync), or Selcall + SDM (FleetSync)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS
3.4 Using
key.
INDEX 310