Kenwood NEXEDGE NX-200 Function Reference page 538

26
MODE
The transceiver has the following modes: the mode for adjusting the transceiver, the mode for copying the configuration
data to another transceiver, and the mode for updating the firmware and confirming the version number of the firmware.
• Panel Test Mode
• Panel Tuning Mode
• Clone Mode
• Firmware Programming Mode
• Firmware Version Information Mode
The transceiver can enter each mode by pressing keys on the transceiver. Whether to permit the use of these modes can
be configured using KPG-111D/ DN.
The transceiver is also equipped with PC Test Mode to be used for testing transmit and receive capabilities of the
transceiver and PC Tuning Mode to be used for adjusting the transceiver by using KPG-111D/ DN.
26.1 Testing the Transmit and Receive Capabilities of the
Transceiver (Panel Test Mode)
Panel Test Mode can be used to test transmit and receive capabilities of the transceiver using the operation panel of the
transceiver.
Note
This function is unavailable for NX-200S/ NX-300S.
Operating the Transceiver
1
Turn the transceiver ON while pressing and holding
the Back key.
A Power-on Tone sounds from the transceiver, and then the
market code of the transceiver and battery type appear for 2 sec.
The transceiver enters Panel Test Mode after a lapse of 2 sec.
FUNC (K)/Ver 4.00
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 504