Intervals (Gps Report Mode); (Gps Report Mode) - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync
12.9 Sending GPS Data
Sending GPS Data Automatically at Certain Intervals (GPS Report Mode)
GPS data can be sent automatically at the intervals configured for GPS Report Interval.
This function is used for controlling or monitoring vehicles on a time basis by periodically transmitting location information
to the base station.
To use this function, "Auto" must be configured for GPS Report Mode by using KPG-111D/ DN.
Note
• The transceiver sends the GPS data upon receipt of the GPS data transmission request from the base station even if "Auto" is
configured for GPS Report Mode.
• If the transceiver is under the following conditions, the automatic transmission of GPS data at certain intervals will be canceled. Also,
the Transmit Busy Wait Time will not suspend the transmission to avoid a collision with a GPS transmission from another transceiver
while sending GPS data. (Refer to
• While the transceiver is transmitting
• While the transceiver is receiving
• While the Public Address function is used (Mobile only)
• While Transmit Frequency or Encode ID is not configured
• While transmission is disabled by the Time-out Timer
• While the transceiver is sending or receiving FleetSync data
• While Auto Telephone is active
• While System Search is active
• While the transceiver is connected to the repeater
• While the transceiver is waiting to send the Transpond tone
• Transceiver Password Mode
• Emergency Mode
Configuration using KPG-111D/ DN
Configuring the GPS Report Mode (
Sending GPS Data According to the Request from the Base Station

(GPS Report Mode)

The transceiver can send GPS data when a GPS data transmission request is received from the base station.
This function is used when the base station controls the timing to require GPS data. This function is also used to avoid
transmit collisions if there are many subscriber units.
To use this function, "Poll" must be configured for GPS Report Mode by using KPG-111D/ DN.
Note
The transceiver sends the GPS data to the ID configured for Base Fleet/ Base ID, not to the ID that sent the data transmission request.
Configuration using KPG-111D/ DN
Configuring the GPS Report Mode (
FUNC (K)/Ver 4.00
Transmit Busy Wait Time on page
FPRG 8.11.4 GPS Tab)
See
See FPRG 8.11.4 GPS Tab)
320.)
CONTENTS INDEX 345