Kenwood NEXEDGE NX-200 Function Reference page 172

8 NXDN CONVENTIONAL SYSTEM
8.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Individual Call
2
Press the Side 2 key (Portable) or the
An acknowledgment message is sent.
After sending the acknowledgment message, by receiving an
Individual Call from the transmitting transceiver which has been
enabled for the communication, an Alert Tone (Individual Call)
sounds from the transceiver and an ID for the transmitting
transceiver appears.
Note
• If the time configured for Initiating/Incoming Reset Time elapses while the transceiver is placed in the state mentioned at Step 1, the
transceiver resets the standby state, and the display reverts to the channel display. (Refer to
to Wait to Receive an Acknowledgment Message (Initiate/Incoming Reset Time) on page
• During Step 1, the transceiver can reject an incoming call by pressing the Side 1 key (Portable), the Triangle key (Mobile) or the [#]
key.
• Pressing the PTT switch at Step 2 initiates an Individual Call to the transmitting transceiver. Not only receiving an acknowledgment
message, but also receiving an Individual Call makes the transmitting transceiver available for the communication.
• If the received Unit ID is configured in the Unit ID List, an Alert Tone sounds from the transceiver according to the configuration for Alert
Tone (Paging Call) of the corresponding Unit ID. If the received Unit ID is not registered in the Unit ID List, the Alert Tone sounds from
the transceiver according to the configuration for Alert Tone (Paging Call) which is commonly used.
 If Automatic Response is enabled:
1
Receive a message requesting an acknowledgment.
An acknowledgment message is automatically sent to the
transmitting transceiver. An Alert Tone (Individual Call) sounds
from the transceiver, and the ID for the transmitting transceiver
appears on the main display.
After sending the acknowledgment message, by receiving an
Individual Call from the transmitting transceiver which has been
enabled for the communication, an Alert Tone (Individual Call)
sounds from the transceiver and an ID for the transmitting
transceiver appears.
Note
• Pressing the PTT switch initiates an Individual Call to the transmitting transceiver. Not only receiving an acknowledgment message,
but also receiving an Individual Call makes the transmitting transceiver available for the communication.
• If the received Unit ID is configured in the Unit ID List, an Alert Tone sounds from the transceiver according to the configuration for Alert
Tone (Individual) of the corresponding Unit ID. If the received Unit ID is not registered in the Unit ID List, the Alert Tone sounds from the
transceiver according to the configuration for Alert Tone (Individual) which is commonly used.
FUNC (K)/Ver 4.00
Square key (Mobile).
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
Configuring the Maximum Length of Time
140.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 138