Kenwood NEXEDGE NX-200 Function Reference page 154

8 NXDN CONVENTIONAL SYSTEM
8.2 Using the Signaling
• If the transceiver receives analog signals
The transceiver behaves according to the configuration for Audio Control (Analog).
• If the transceiver receives digital signals
The transceiver behaves according to the configuration for Audio Control (NXDN).
Note
Refer to Unmuting the Speaker (Audio Control (Analog)) on page 261
(Analog).
Configuration using KPG-111D/ DN
Configuring the Audio Control (NXDN) (
Temporarily Disabling the Signaling (Monitor)
Monitor is the function that temporarily disables the RAN code and Optional Signaling that are configured for a channel on
which the transceiver waits.
Monitor is used to check the availability of channels prior to transmitting in order to prevent from interfering with other
parties.
To use this function, the Monitor key or the Monitor Momentary key must be used.
Or, pressing the Menu key causes the transceiver to enter Menu Mode, and then Monitor can be toggled between enabled
and disabled by selecting the "Monitor". (Refer to
While Monitor is enabled, the "
On a channel where "Mixed" is configured for Channel Type, while Monitor is enabled, the "
code, QT tone or DQT code, and Analog or NXDN Optional Signaling will be disabled.
Operating the Transceiver
 Monitor key
1
Press the Monitor
The " " icon appears. For NX-200S/ NX-300S, Key Beep A
sounds from the transceiver.
The transceiver disables the RAN code and Optional Signaling
and unmutes the speaker upon detection of an NXDN frame.
FUNC (K)/Ver 4.00
See FPRG 8.2.7 Audio Control (NXDN))
3.4 Using Menu Mode on page
" icon appears, and the RAN code and Optional Signaling will be disabled.
key while Monitor is disabled.
for details on the transceiver behavior of the Audio Control
23.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
" icon appears, and the RAN
Mobile
INDEX 120