Changing The Zone-Channel Or Gid; Changing The Zone - Kenwood NEXEDGE NX-200 Function Reference

3 BASIC OPERATIONS

3.5 Changing the Zone-channel or GID

3.5 Changing the Zone-channel or GID
The Zone-channel or GID can be changed using the Selector (Portable only) or PF keys.

Changing the Zone

The zone can be changed by operating the Selector (Portable only) or PF keys.
Portable
 Changing the zone according to the number indicated by the pointer of the Selector (NX-200/ NX-200S/
NX-300/ NX-300S only)
Rotating the Selector causes the transceiver to migrate to the zone having the same number specified by the
Selector. Zones that can be selected are limited to zone 1 to zone 16.
For NX-200S/ NX-300S, zones that can be selected are limited to zone 1 to zone 4.
If an unprogrammed zone is selected, "**************" appears on the main display.
For NX-200/ NX-300, this behavior can be realized by installing a stopper on the Selector, enabling 16 Zone/Channel
Selector, and assigning the Zone Select function to the Selector. (Refer to
(Portable Only) on page
 Changing the zone regardless of the number indicated by the pointer of the Selector (NX-200/
NX-210/ NX-300/ NX-410/ NX-411 only)
Rotating the Selector clockwise increases the zone number in steps of 1. Rotating the Selector counterclockwise
decreases the zone number in steps of 1.
If an unprogrammed zone is selected, the zone will be skipped.
For NX-200/ NX-300, this behavior can be realized by disabling 16 Zone/Channel Selector and assigning the Zone Up/
Down function to the Selector. (Refer to
 Changing the zone by using the PF key
Pressing the Zone Up key increases the zone number in steps of 1. Pressing the Zone Down key decreases the zone
number in steps of 1.
If "Zone Up (Continuous)" or "Zone Down (Continuous)" is assigned to the Zone Up or Zone Down key, the zone
number will be increased or decreased continuously every 200 ms by holding down the Zone Up or Zone Down key.
If an unprogrammed zone is selected, the zone will be skipped.
Note
• Operation for changing the zone varies depending on the configuration for Rollover/ End Stop. (Refer to
28.)
• For NX-200S/ NX-300S, zones that can be selected are limited to zone 1 to zone 4. When a zone is selected, the transceiver emits the
following tones according to the selected zone.
Zone 1: Zone 1 Select Tone (A tone sounds once.)
Zone 2: Zone 2 Select Tone (A tone sounds twice.)
Zone 3: Zone 3 Select Tone (A tone sounds three times.)
Zone 4: Zone 4 Select Tone (A tone sounds four times.)
In this case, even if "Rollover" is configured for Rollover/ End Stop, no Rollover Tone sounds from the transceiver. However, if Zone-
CH/GID Guide of the VGS-1 unit is used, the above tone will not sound from the transceiver, but a Rollover Tone will sound. (Refer to
Rollover/ End Stop on page
• For NX-200S/ NX-300S, 16 Zone/Channel Selector is always configured to be enabled.
• For NX-210/ NX-410/ NX-411, 16 Zone/Channel Selector is always configured to be disabled.
FUNC (K)/Ver 4.00
523.)
Available Functions for the Selector (Portable Only) on page
28, Using the Voice Guide (Voice Guide) on page 470.)
Available Functions for the Selector
523.)
Rollover/ End Stop on page
CONTENTS INDEX 26