Kenwood NEXEDGE NX-200 Function Reference page 489

19 SCAN
19.8 Common Functions for Scan
Lookback Time B
Lookback Time B is the interval time to check for a signal that has unmatched QT tone, DQT code, or RAN code on a
Priority Channel while the transceiver is receiving a signal on a normal channel during the Priority Scan.
Configuration using KPG-111D/ DN
• Configuring the Lookback Time A (
• Configuring the Lookback Time B (
Activating the Carrier Squelch on a Priority Channel (AC Control)
AC Control is a function to activate the carrier squelch by deactivating the QT tone or DQT code on a Priority Channel
during the Priority Scan.
If this function is activated, the transceiver can quickly migrate to a Priority Channel since the transceiver does not need to
check the QT tone or DQT code. A user can monitor conversations on all Priority Channels when another group having a
different priority channel is using this function during the Priority Scan.
Note
This function can be only used in an Analog Conventional system.
Configuration using KPG-111D/ DN
Configuring the AC Control to be enabled or disabled (
Priority 1 Temporary Delete/Add, Priority 2 Temporary Delete/Add
A Priority Channel is always scanned regardless of the Scan Delete/Add configuration. If this function is enabled, pressing
the Scan Delete/Add key temporarily deletes a Priority Channel from the target channels for scanning when the scan
pauses on the Priority Channel.
Configuration using KPG-111D/ DN
• Configuring the Priority 1 Temporary Delete/Add (
• Configuring the Priority 2 Temporary Delete/Add (
Revert CH/GID Display
Revert CH/GID Display is a function to display the Revert Zone-channel or GID on the main display during the scan.
Configuration using KPG-111D/ DN
Configuring the Revert CH/GID Display to be enabled or disabled (
FUNC (K)/Ver 4.00
See FPRG 8.13.1 Scan Tab)
See FPRG 8.13.1 Scan Tab)
FPRG 8.13.1 Scan Tab)
See
FPRG 8.13.1 Scan Tab)
See
FPRG 8.13.1 Scan Tab)
See
See FPRG 8.13.1 Scan Tab)
CONTENTS INDEX 455