Kenwood NEXEDGE NX-200 Function Reference page 156

8 NXDN CONVENTIONAL SYSTEM
8.2 Using the Signaling
Transceiver Behavior during the Scan
In a Conventional Group, the transceiver disables the signaling and unmutes the speaker only with a carrier, and then
remains in the standby state.
Pressing the Monitor key during the scan causes the "
appears, the transceiver disables the RAN code and Optional Signaling, and unmutes the speaker upon detection of an
NXDN frame in the same manner as when the scan is deactivated.
If the Monitor Momentary key is pressed during the scan, the transceiver disables the RAN code and Optional Signaling,
and unmutes the speaker upon detection of an NXDN frame in the same manner as when the scan is deactivated. The
scan continues in this case, too. Pressing the Monitor Momentary key never causes the scan to be deactivated.
Unmuting the Speaker by Linking with the Microphone (Off-hook Decode)
(Mobile Only)
Off-hook Decode is the function linked with a microphone on- or off-hook state to unmute the speaker upon detection of an
NXDN frame.
The transceiver behaves as follows according to the configuration for Off-hook Decode.
Configuration
The transceiver opens the squelch according to the configuration for Audio Control while the microphone is in either
Enabled
the on-hook state or off-hook state.
The transceiver unmutes the speaker when the transceiver detects a frame if the microphone is in the off-hook state.
Disabled The transceiver opens squelch according to the configuration for Audio Control if the microphone is in the on-hook
state.
Note
• If "Mixed" is configured for Channel Type, the transceiver behavior varies according to the type of a received signal (Analog or NXDN).
(Refer to Unmuting the Speaker by Linking with the Microphone (Off-hook Decode) (Mobile Only) on page
• Stun can be activated regardless of the status of Off-hook Decode and the microphone on- or off-hook state.
• The matching state of Optional Signaling will be reset by hooking the microphone on a hanger (On-hook state) after receiving a call by
Optional Signaling.
Configuration using KPG-111D/ DN
Configuring the Off-hook Decode to be enabled or disabled (
FUNC (K)/Ver 4.00
" icon to appear and the scan to continue. While the "
Table 8-5 Off-hook Decode
Description
See FPRG 8.10.1 Common Page 1 Tab)
264.)
CONTENTS INDEX
" icon
122