Kenwood NEXEDGE NX-200 Function Reference page 261

9 NXDN TRUNKING SYSTEM
9.8 Making a Group Call with the Link to a Traffic Channel Retained (Message Trunked (Enhanced))
Note
• The DTMF code can be sent during the call by pressing one of the [0] key to [9] key, the [*] key or the [#] key while pressing and
holding the PTT switch.
• If Call Request Tone is enabled, a Call Request Tone sounds from the transceiver when a call requesting an Group Call (Message
Trunked (Enhanced)) is initiated. Also, if Call Processing Tone is enabled, a Call Processing Tone sounds from the transceiver until the
transceiver receives from the system a message for traffic channel assignment after the call requesting a Group Call (Message
Trunked (Enhanced)) is initiated. (Refer to
Notifying the User with a Tone That a Call Request Is in Progress (Call Processing Tone) on page
• If PTT Proceed Tone is enabled, a Proceed Tone sounds from the transceiver when the transceiver becomes ready for
communications after the PTT switch is pressed. (Refer to
Tone) on page 92.)
• For Mobile, if Mic On-hook Disconnect is enabled, a Group Call ends by placing the microphone in the on-hook state.
• For details on the information displayed on the main display during transmission, refer to
Receiving a Group Call (Message Trunked (Enhanced))
If the received Group ID matches the Group ID configured for the transceiver, the transceiver can receive the Group Call.
Transceiver Behavior
1
The transceiver receives a Group Call.
If a traffic channel has been assigned, the transceiver emits an
Alert Tone (Conference Group Call), and either the received
Group ID or the Unit ID for the transmitting transceiver, or both
IDs, appear on the main display. For a Broadcast Group Call, the
transceiver emits an Alert Tone (Broadcast Group Call).
Note
• The DTMF code can be sent during the call by pressing one of the [0] key to [9] key, the [*] key or the [#] key while pressing and
holding the PTT switch.
• The Group Call ends by pressing the Side 1 key (Portable), the Triangle key (Mobile) or the [#] key. For Mobile, if Mic On-hook
Disconnect is enabled, a Group Call ends by placing the microphone in the on-hook state.
• An Alert Tone sounds from the transceiver according to the configuration of GID corresponding to the received Group ID.
Configuration using KPG-111D/ DN
• Configuring the Alert Tone (Zone Information) (
System))
• Configuring the Alert Tone (Conference Group Call) which is commonly used (
FUNC (K)/Ver 4.00
Notifying the User with a Tone That a Call Request Has Been Initiated (Call Request Tone)/
Using Sound to Notify the Timing to Start Communications (PTT Proceed
See FPRG 8.1.4 Zone Information Window (NXDN Trunking
212.)
 Display during transmission on page
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
FPRG 8.19.4 Trunking Tab)
See
CONTENTS INDEX
207.
227