Kenwood NEXEDGE NX-200 Function Reference page 480

19 SCAN
19.7 Transceiver Behavior during the Scan
19.7 Transceiver Behavior during the Scan
Note
The amount of time from when the transceiver pauses scanning for transmission or reception until the transceiver resumes scanning
can be configured using Dropout Delay Time and Dwell Time. (Refer to
Conditions to Activate the Scan
If the Scan key is pressed while the transceiver is not scanning or the "Scan" is selected after entering Menu Mode by
pressing the Menu key, the transceiver starts one of Single Scan, Multi Scan, or List Scan according to the configuration
for Scan Type.
One of the following conditions must be met to activate the scan. An Error Tone sounds when the conditions do not meet
the requirements to activate scan.
 If the transceiver starts scanning in a zone in an NXDN Trunking system:
Two or more GID targeted to be scanned must exist in the zone targeted to be scanned.
 If the transceiver starts scanning in a zone other than a zone in an NXDN Trunking system:
• Two or more channels or GID targeted to be scanned must exist in the zone targeted to be scanned.
• One channel or GID targeted to be scanned must exist in the zone targeted to be scanned, and a Priority Channel
must exist in the zone or other zones.
• If there is no channel or GID targeted to be scanned in the zone targeted to be scanned, Priority Channel 1 and
Priority Channel 2 must exist in the same zone or other zones.
The zones targeted to be scanned mentioned above stand for the following zones.
 If "Single" is configured for the Scan Type:
The selected zone
 If "Multi" or "List" is configured for the Scan Type:
• The zones in an NXDN Trunking system (if the scan starts from zones in an NXDN Trunking system)
• The zones in a Conventional Group or an LTR Trunking system (if the scan starts from zones other than the
zones in an NXDN Trunking system)
Conditions to Resume the Scan
One of the following conditions must be met to resume scanning while the transceiver pauses scanning. If the transceiver
does not meet the conditions to resume scanning, the "
 For the zone in an NXDN Trunking system
Two or more GID targeted to be scanned must exist in the zone targeted to be scanned.
 For the zone other than a zone in an NXDN Trunking system
• One channel or GID targeted to be scanned must exist in the zone targeted to be scanned, and a Priority Channel
must exist in the zone or other zones.
• If there is no channel or GID targeted to be scanned in the zone targeted to be scanned, Priority Channel 1 and
Priority Channel 2 must exist in the same zone or other zones.
The zones targeted to be scanned mentioned above stand for the following zones.
 If "Single" is configured for the Scan Type:
The selected zone
FUNC (K)/Ver 4.00
Dropout Delay Time on page
" icon blinks and scanning pauses.
CONTENTS
454, Dwell Time on page 454.)
INDEX 446