Kenwood NEXEDGE NX-200 Function Reference page 409

14 DTMF
14.5 Functions Related to DTMF Code Decoding
Connecting to a Telephone Line (Auto Telephone)
Auto Telephone is a function allowing the transceiver to connect to a telephone line in an LTR Trunking system.
After the transceiver enters Autodial Mode in an LTR Trunking system, pressing the Side 2 key (Portable) or Square key
(Mobile) causes the transceiver to search for an available system that can connect to a telephone line. If the transceiver
succeeds in connecting to a system that can connect to a telephone line, the transceiver sends the DTMF code. (Refer to
Automatically Connecting to a Telephone Line (Auto Telephone Search) on page
Note
Autodial Mode is unavailable for NX-200S/ NX-300S. For NX-200S/ NX-300S, the transceiver can search for an available system that
can connect to a telephone line by pressing the Auto Telephone key.
Configuration using KPG-111D/ DN
Configuring the Auto Telephone to be enabled or disabled (
14.5 Functions Related to DTMF Code Decoding
Functions related to DTMF code decoding are shown below.
• Code
• Transpond
• Alert Tone
• Selective Call Alert LED
• Auto Reset Timer
• Clear to Transpond
Note
DTMF codes cannot be decoded in an NXDN Trunking system.
Standby Code (Code)
Code is the standby DTMF code for receiving an individual call.
If the received DTMF code matches the standby DTMF code, Alert Tone, Transpond and LED (Selective Call Alert LED)
will be activated.
Note
"DTMF" must be configured for Optional Signaling used by the channel or GID. (Refer to
119, Using the Optional Signaling (Analog) on page
Configuration using KPG-111D/ DN
Configuring the Code ( See
FUNC (K)/Ver 4.00
261, 11.2 Using the Optional Signaling (LTR) on page
FPRG 8.14.2 Decode Tab)
291.)
FPRG 8.14.1 Encode Tab)
See
Using the Optional Signaling (NXDN) on page
CONTENTS
285.)
INDEX 375