Changing The Channel Or Gid With A Single Touch - Kenwood NEXEDGE NX-200 Function Reference

3 BASIC OPERATIONS
3.5 Changing the Zone-channel or GID
2
Enter a Group ID.
The following are examples for entering a Group ID.
• If the maximum Group ID has 5 digits:
To enter Group ID 21250, press the [2], [1], [2], [5] and [0] keys in this order.
To enter Group ID 1250, press the [0], [1], [2], [5] and [0] keys in this order.
To enter Group ID 250, press the [0], [0], [2], [5] and [0] keys in this order.
To enter Group ID 90, press the [0], [0], [0], [9] and [0] keys in this order.
To enter Group ID 7, press the [0], [0], [0], [0] and [7] keys in this order.
• If the maximum Group ID has 4 digits:
To enter Group ID 1250, press the [1], [2], [5] and [0] keys in this order.
To enter Group ID 250, press the [0], [2], [5] and [0] keys in this order.
To enter Group ID 90, press the [0], [0], [9] and [0] keys in this order.
To enter Group ID 7, press the [0], [0], [0] and [7] keys in this order.
• If the maximum Group ID has 3 digits:
To enter Group ID 250, press the [2], [5] and [0] keys in this order.
To enter Group ID 90, press the [0], [9] and [0] keys in this order.
To enter Group ID 7, press the [0], [0] and [7] keys in this order.
• If the maximum Group ID has 2 digits:
To enter Group ID 90, press the [9] and [0] keys in this order.
To enter Group ID 7, press the [0] and [7] keys in this order.
• If the maximum Group ID has 1 digit:
To enter Group ID 7, press the [7] key.
3
Press the Menu ([
The transceiver will migrate to the configured GID of the Group ID entered, after ending Group ID Entry Mode.
If there is no configured GID of the Group ID entered, the transceiver exits Group ID Entry Mode and the Key-entry Error Tone
sounds from the transceiver.
Note
• Refer to Key Operations for Each Mode on page 531
• Pressing the PTT switch while in Group ID Entry Mode causes the transceiver to transmit on the GID selected before the transceiver
enters Group ID Entry Mode. If the GID is changed during Group ID Entry Mode, pressing the PTT switch initiates transmission with
the GID changed.
• This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Assigning functions to the PF keys on the transceiver (

Changing the Channel or GID with a Single Touch

The channel or GID can be changed with a single touch by using the Home CH/GID or Direct CH/GID function.
Other than these functions, in an NXDN Trunking system, the transceiver can automatically migrate to the Home GID by
using the Home Group Revert function (Auto) when the transceiver is turned ON.
FUNC (K)/Ver 4.00
]) key.
for key operations for entering the Group ID in Group ID Entry Mode.
FPRG 8.12 Key Assignment Window)
See
CONTENTS INDEX 31