Restricting The Transmission Of The Ptt Id In Talk Around (Restricted Id In Talk Around); Disabling The Transceiver Capability By Remote Control (Stun) - Kenwood NEXEDGE NX-200 Function Reference

14 DTMF

14.3 Disabling the Transceiver Capability by Remote Control (Stun)

Restricting the Transmission of the PTT ID in Talk Around
(Restricted ID in Talk Around)
Restricted ID in Talk Around is a function to disable the PTT ID transmission while Talk Around is enabled even if the PTT
switch is pressed or released.
This function is available when PTT ID is not required such as when directly communicating with other transceivers.
Note
This function can be only used in an Analog Conventional system.
Configuration using KPG-111D/ DN
Configuring the Restricted ID in Talk Around to be enabled or disabled (
14.3 Disabling the Transceiver Capability by Remote Control
(Stun)
The transceiver capability can be disabled by wireless remote control. This function allows an system administrator to
remotely disable the transceiver, for instance, if the transceiver is lost.
The transceiver which has been disabled by this function can be enabled to be usable again by remote control from an
external device using radio communication.
When the transceiver receives the Stun Code, the transceiver multiplexes the Stun-on Tone and starts transponding. Then,
the function configured in the Stun Code Response will be activated.
The function configured in the Stun Code Response is stored even if the transceiver is turned OFF. The state of Stun Code
Response cannot be reset by Auto Reset Timer or by the user's operation. The transceiver transmits the Stun-off Tone and
then resets the state of Stun Code Response when the transceiver receives the Revive Code (Stun Code + "#").
Stun Code and Stun Code Response can be configured in the transceiver using KPG-111D/ DN.
Configuration
Stun Code Stun Code is a standby code for Stun.
Stun Code Response can configure as below how the transceiver will respond when the Stun Code matches.
Transmit Inhibit:
Stun Code Transmit capability is disabled. User operations of the transceiver are also inhibited. Automatic transmission, such
Response as Transpond, is still available.
Transceiver Inhibit:
Transmit and receive capabilities are disabled. User operations of the transceiver are also inhibited.
Note
The transceiver cannot enter Emergency Mode while Stun is enabled.
Configuration using KPG-111D/ DN
• Configuring the Stun Code (
• Configuring the Stun Code Response (
FUNC (K)/Ver 4.00
Table 14-3 Stun
See FPRG 8.14.2 Decode Tab)
See FPRG 8.14.2 Decode Tab)
See FPRG 8.11.1 Conventional Tab)
Description
CONTENTS INDEX 371