Kenwood NEXEDGE NX-200 Function Reference page 546

APPENDIX
Available Functions for the PF Keys
Function Name
Emergency
Fixed Volume
Forced Search
Forced Search Function
Function
GPS Position Display
Group ID/Channel Entry
Group (NXDN)
FUNC (K)/Ver 4.00
Enters Emergency Mode. (Refer to
EMERGENCY on page 393.)
Note
• For Portable, this function can be assigned to the AUX key or the PF 1
key of the speaker microphone.
• For Mobile, this function can be assigned to the Triangle key.
• Emergency-key Delay Time will be applied to the key preprogrammed
as "Emergency".
Changes the tone level in the following order: Low  High  Off. (Refer
to 6 SOUND on page 84.)
The selected site number appears for 2 sec. Pressing and holding the
Forced Search key causes the transceiver to start a Control Channel
Hunt.
Note
For NX-200S/ NX-300S, this function cannot be assigned.
For a transceiver with the exception of NX-200S/ NX-300S, pressing and
holding the Forced Search key causes the transceiver to start a Control
Channel Hunt. For NX-200S/ NX-300S, pressing the Forced Search
Function key causes the transceiver to start a Control Channel Hunt.
Waits for activation of Key Function assigned to the 2nd Function and
starts counting down the Mode Reset Timer. The Function status will be
reset if no key is pressed before the amount of time configured for Mode
Reset Timer elapses.
Enters GPS Position Display Mode. (Refer to
on page 388.)
Note
For NX-200S/ NX-300S, this function cannot be assigned.
If the zone in an NXDN Trunking system is selected, the Group ID in the
NXDN Trunking system can be specified directly by using the keypad.
(Refer to Changing the GID by Specifying the ID (Group ID Entry) (NXDN
Trunking System Only) on page
If the zone other than in an NXDN Trunking system is selected, the
channel number can be specified directly by using the keypad. (Refer to
Changing the Channel or GID by Specifying the Number (Channel Entry)
on page 29.)
Note
For NX-200S/ NX-300S, this function cannot be assigned.
Enters Group Call Mode for an NXDN Conventional system. In Group
Call Mode, a Group Call can be initiated by selecting a Group ID
configured in the Group ID List. (Refer to
SYSTEM on page 109.)
Note
• In an NXDN Trunking system, Group ID List can be viewed, but a
Group Call cannot be initiated by selecting a Group ID.
• For NX-200S/ NX-300S, this function cannot be assigned.
Description
16 COMMUNICATIONS IN AN
15.2 GPS Position Display
30.)
8 NXDN CONVENTIONAL
Available System
ALL
ALL
NXDN Trunking System
NXDN Trunking System
ALL
ALL
ALL
NXDN Conventional System
CONTENTS INDEX
*1
512