Kenwood NEXEDGE NX-200 Function Reference page 354

12 FleetSync
12.5 Common Functions for Data Communications
Transmit Busy Wait Time
The transceiver confirms that the communication channel is available before sending data and then starts sending data
when the channel is available. Transmit Busy Wait Time is the duration to wait for the communication channel to become
available.
A transmission is canceled when the channel is busy and the Transmit Busy Wait Time elapses.
The default configuration is normally used.
Configuration using KPG-111D/ DN
Configuring the Transmit Busy Wait Time (
Maximum ACK Wait Time
Maximum ACK Wait Time is the length of time that the transceiver stands by to receive the acknowledgment after the
transceiver sends data. If the transceiver does not receive the acknowledgment within the time configured for Maximum
ACK Wait Time, the transceiver resends data.
The default configuration is normally used.
Note
• This period can also be used for waiting on a data channel, after migrating to the data channel using the GTC.
• A Long Data Message transmits data divided over multiple times. The receiving transceiver stands by to receive the next data for the
time configured for Maximum ACK Wait Time after receiving the previous data. The transceiver exits Long Data Message Receive
Mode if the transceiver does not receive any data during the period.
Configuration using KPG-111D/ DN
Configuring the Maximum ACK Wait Time (
ACK Delay Time
ACK Delay Time is the length of time from when the transceiver receives data until the transceiver sends the
acknowledgment.
ACK Delay Time must be shorter than Maximum ACK Wait Time configured for the transmitting transceiver. Also, if the
ARQ is used in an LTR Trunking system, the ACK Delay Time must be configured to be shorter than the Hold Time of the
repeater. (Refer to Terminating Data Communication by a Single Link (ARQ Mode) on page
The default configuration is normally used.
Configuration using KPG-111D/ DN
Configuring the ACK Delay Time (
FUNC (K)/Ver 4.00
FPRG 8.16.4 Parameter Tab)
See
FPRG 8.16.4 Parameter Tab)
See
See FPRG 8.16.4 Parameter Tab)
297.)
CONTENTS INDEX 320