Notifying Status Changes Of The Transceiver By Sending Pc Commands (J Command Serial Output) - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync

12.12 Notifying Status Changes of the Transceiver by Sending PC Commands (J Command Serial Output)

12.12 Notifying Status Changes of the Transceiver by Sending PC
Commands (J Command Serial Output)
J Command Serial Output is used to notify a user when the transceiver status is changed (information shown on the
display is changed or a function is enabled or disabled and the volume level is changed, etc.) by sending a PC command.
Whether a PC command is automatically sent when the transceiver's status changes or a PC command is sent only if the
transceiver receives a command from a PC can be configured using KPG-111D/ DN.
Note
For Mobile, the PC command such as J Command cannot be sent from the COM port 0. (Refer to
page 524.)
Configuration using KPG-111D/ DN
Configuring the J Command Serial Output (
FUNC (K)/Ver 4.00
FPRG 8.10.6 Common Page 4 Tab)
See
Available Functions for COM Port on
CONTENTS INDEX 350