Replacing The Process Turning Disc - ABB IRB 8700 Series Product Manual

4 Repair

4.5.5 Replacing the process turning disc

4.5.5 Replacing the process turning disc
Location of the process turning disc
The process turning disk is located as shown in the figure.
Required spare parts
Spare part
Process turning disc
Required tools and equipment
Equipment, etc.
Roundsling 1 m
Standard toolkit
Removing the process turning disc
Use these procedures to remove the process turning disc.
Preparations before removing the process turning disk
1
2
3
Continues on next page
346
Note
The spare part numbers that are listed in the table can be out of date. See the
latest revision of Product manual, spare parts - IRB 8700on ABB Library.
Action
Jog the robot to a comfortable position for
removing the process turning disk.
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
Remove any tools or other equipment (in-
cluding the DressPack) fitted to the process
turning disk.
© Copyright 2015-2018 ABB. All rights reserved.
Article number
3HAC051003-005
Article number Note
- Lifting capacity: 1,000 kg
- Content is defined in section
toolkit on page
Note
Note
Standard
833.
Product manual - IRB 8700
3HAC052853-001 Revision: F