ABB IRB 8700 Series Product Manual page 745

Refitting the motor flange
1
2
3
4
5
6
7
8
9
Product manual - IRB 8700
3HAC052853-001 Revision: F
Action
Remove the three M16x130 screws and six-hole
washers, previously attached in a triangle.
Clean the contact surfaces on gearbox and motor
flange.
Clean o-rings and o-ring groove on gearbox.
Inspect the o-rings. Replace if damaged!
Apply some grease on the o-rings.
Attach the smaller o-ring in the gearbox groove.
Attach the larger o-ring on the motor flange.
Before lifting the motor flange onto the guide pins,
make sure the oil inspection glass is facing at six
o'clock. See figure.
Lift the motor flange onto the guide pins.
© Copyright 2015-2018 ABB. All rights reserved.
4.8.4 Replacing the axis-3 gearbox
Note
xx1500002347
xx1500002353
Grease
xx1500002354
xx1500002314
Continues on next page
4 Repair
Continued
745