ABB IRB 8700 Series Product Manual page 81

Required equipment
It is necessary to use guide pins when securing the robot to a base plate.
XX1500000248
A
Attachment screws
Securing the robot to the base plate/foundation
The table below specifies the type of securing screws and washers to be used for
securing the robot to the base plate/foundation.
Suitable screws, lightly lubricated:
Quantity:
Quality:
Screw tightening yield point utilization factor (v)
(according to VDI2230):
Suitable washer:
Tightening torque:
Product manual - IRB 8700
3HAC052853-001 Revision: F
25g6
12k6
Cylindrical guide pin
© Copyright 2015-2018 ABB. All rights reserved.
2 Installation and commissioning
2.3.8 Orienting and securing the robot
M24 x 100
12 pcs
8.8
90% (v=0.9)
4 mm flat washer
550 Nm (screws lubricated with Molykote
1000)
600-725 Nm, typical 650 Nm (screws none
or lightly lubricated)
Continues on next page
Continued
(A)
81