ABB IRB 8700 Series Product Manual page 228

4 Repair
4.4.2 Refitting the cable harness
Continued
4
5
6
7
Continues on next page
228
Action
Refit the cable clamp on the axis-3 bracket.
Refit the cable clamp on the axis-3 bracket,
between axis-4 motor and arm housing.
Secure the cable harness with a cable tie.
Make sure that the gasket on the cover is
correctly fitted.
Note
Replace if damaged.
The gasket is covered with adhesive on the
side facing the upper arm cover. The three
washers are pressed into the holes in the
gasket. Make sure all three washers are
fitted.
© Copyright 2015-2018 ABB. All rights reserved.
Note
xx1500002718
xx1500003092
xx1500003093
xx1500003094
Product manual - IRB 8700
3HAC052853-001 Revision: F